What is the difference between the Artist 1•2 and Producer 2•2?

Both units are high quality USB audio interfaces. The Artist 1•2 offers 1 OnyxTM microphone preamp and 1 Line/Instrument input. The Producer 2•2 offers 2 combo jacks with 2 OnyxTM microphone preamps that will accept either XLR or 1/4” inputs. Additionally, the Producer offers a mix for direct monitoring, and MIDI in and out options.

Can you run the Onyx USB Interfaces without being connected to a computer?

No, there needs to be a computer contected to the units. It will not operate if connected to only a 5VDC USB power source.

How are they powered?

They are both powered by the 5V supplied through the USB connection. No external power source is required.

What operating systems will work with the Onyx USB Interfaces?

Both units will work with Mac or PC. Windows 7®(32 and 64 bit) or Later. Minimum hardware requirements: Intel Core 2 Duo 2 GHz processor 4 GB RAM USB 2.0 port. For the latest driver information please check our website.

What sample rates and bit depths will the Onyx USB Interfaces offer?

Both units will run at either 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, or 192 kHz. They will both have a bit depth of either 16 or 24 bits.

What is Direct Monitoring?

Direct monitoring gives you the ability to hear channels 1 and 2 right from the preamp. It is the unprocessed signal going into the unit. This is perfect for latency-free monitoring of what you are recording.

What does the Hi-Z button do?

The Hi-Z button changes the impedance of the 1/4” input. This allows you to connect a guitar or bass directly to the input.

Will Phantom power (48v) hurt my instrument or line level device?

Phantom power (48v) is only supplied through pins 2 and 3 on the XLR connection. Your instrument or line level devices are safe.

What is the headphone output impedance?

The headphone output impedance is 10 ohms.

FAQs | MACKIE

How can I hook up multiple speakers to one amplified channel of my mixer? Is there a special way to do that?

You would make a connection like this by coming out of the amplifier to the input of one of your speakers, and then out of that speaker’s THRU jack into the input of your next speaker. See picture below.

How many of the C200 or the C300z can I daisy chain together?

This really depends on your amplifier; there is a limit to how low of an ohm load you can run on each channel. Some amplifiers can go all the way down to a 2 ohm load and there are some that require an 8 ohm load. After you find out what your amplifier requires you can find out how many you can hook up to each amplified channel. For example two C300Z’s equal a 4 ohm load, three C300Z’s equals a 2.67 ohm load, and four C300Z’s all cabled together would bring it down to a 2 ohm load.

I’m not hearing anything? It looks like I have everything plugged in correctly? What’s the deal?

Here are some things to check! Are the level controls on the mixer or amplifier turned all the way down? Is the signal source working? Make sure all the connecting cables are in good repair and securely connected at both ends. Also make sure your amplifier and mixer are currently on!

What is the input impedance of the C200/C300Z?

The C200 and the C300Z both have an input impedance of 8 ohms.

FAQs

Subscribe to our newsletter

Follow us on