FAQs

You would make a connection like this by coming out of the amplifier to the input of one of your speakers, and then out of that speaker’s THRU jack into the input of your next speaker. See picture below.

This really depends on your amplifier; there is a limit to how low of an ohm load you can run on each channel. Some amplifiers can go all the way down to a 2 ohm load and there are some that require an 8 ohm load. After you find out what your amplifier requires you can find out how many you can hook up to each amplified channel. For example two C300Z’s equal a 4 ohm load, three C300Z’s equals a 2.67 ohm load, and four C300Z’s all cabled together would bring it down to a 2 ohm load.

Here are some things to check! Are the level controls on the mixer or amplifier turned all the way down? Is the signal source working? Make sure all the connecting cables are in good repair and securely connected at both ends. Also make sure your amplifier and mixer are currently on!

The C200 and the C300Z both have an input impedance of 8 ohms.