What is the difference between the Artist 1•2 and Producer 2•2?

Both units are high quality USB audio interfaces. The Artist 1•2 offers 1 OnyxTM microphone preamp and 1 Line/Instrument input. The Producer 2•2 offers 2 combo jacks with 2 OnyxTM microphone preamps that will accept either XLR or 1/4” inputs. Additionally, the Producer offers a mix for direct monitoring, and MIDI in and out options.

Can you run the Onyx USB Interfaces without being connected to a computer?

No, there needs to be a computer contected to the units. It will not operate if connected to only a 5VDC USB power source.

How are they powered?

They are both powered by the 5V supplied through the USB connection. No external power source is required.

What operating systems will work with the Onyx USB Interfaces?

Both units will work with Mac or PC. Windows 7®(32 and 64 bit) or Later. Minimum hardware requirements: Intel Core 2 Duo 2 GHz processor 4 GB RAM USB 2.0 port. For the latest driver information please check our website.

What sample rates and bit depths will the Onyx USB Interfaces offer?

Both units will run at either 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, or 192 kHz. They will both have a bit depth of either 16 or 24 bits.

What is Direct Monitoring?

Direct monitoring gives you the ability to hear channels 1 and 2 right from the preamp. It is the unprocessed signal going into the unit. This is perfect for latency-free monitoring of what you are recording.

What does the Hi-Z button do?

The Hi-Z button changes the impedance of the 1/4” input. This allows you to connect a guitar or bass directly to the input.

Will Phantom power (48v) hurt my instrument or line level device?

Phantom power (48v) is only supplied through pins 2 and 3 on the XLR connection. Your instrument or line level devices are safe.

What is the headphone output impedance?

The headphone output impedance is 10 ohms.

FAQs | MACKIE

Do NOT connect a balanced cable from your receiver to any input on your mixer. This will result in phase cancellation. Instead, use either a stereo breakout (3.5mm to dual TS) or mini stereo (1/8" to 1/8") cable to connect to your mixer.

You can either use both stereo TS cables from your breakout cable to feed a pair of 1/4" inputs or just connect one to the 1/4" input of your choice. Either way, always connect your receiver with an unbalanced cable.

FAQs

Subscribe to our newsletter

Follow us on